For PMDG 737 NGXu support the SPAD.neXt Beta 0.9.7 is needed.
An updated LVAR bridge setup with Prepar3d v5 support is available at https://www.spadnext.com/download/SPAD. ... .Setup.zip

SAITEK SWITCH PANEL NOT RECOGNIZED

General Discussions
Post Reply
Flight [Z-6]
Passenger
Posts: 8
Joined: 26 May 2020, 13:36
Location: Houston, TX USA
Status: Offline

SAITEK SWITCH PANEL NOT RECOGNIZED

Post by Flight [Z-6] » 26 May 2020, 13:48

All, I am new to SPAD.neXt and just completed the installation. I have chose to try this for the sole purpose of connecting my three (3) Saitek devices to my Cockpit.

SWITCH PANEL
MULTI FUNCTION PANEL
RADIO PANEL

I am using X-Plane 11.50b9 on a Windows 10Pro system. My hope was this software would do what Saitek default would not - connect all three via plug-n-play. SPAD/neXt does not recognize the SWITCH PANEL. The other two are working fine so what do I need to do to get the Switch panel to work.

Thanks,

Flight

Flight [Z-6]
Passenger
Posts: 8
Joined: 26 May 2020, 13:36
Location: Houston, TX USA
Status: Offline

Re: SAITEK SWITCH PANEL NOT RECOGNIZED

Post by Flight [Z-6] » 27 May 2020, 15:48

Well, after playing around with the hardware it appears the Switch panel may have a loose connection in the wire feeding into the unit. It is working now. Next, to figure out how to program the features. All three panels were loaded as default and worked but my SAITEK Pro Throttle responded but would not throttle the Falcon 7X I am configuring it for so, back to the drawing board.

Post Reply