For PMDG 737 NGXu support the SPAD.neXt Beta 0.9.7 is needed.
An updated LVAR bridge setup with Prepar3d v5 support is available at https://www.spadnext.com/download/SPAD. ... .Setup.zip

Who's using Arduino's

Discussion about special hardware
User avatar
Oz Flyer
Betatester
Posts: 722
Joined: 23 Sep 2015, 10:10
Location: YMMB, Melbourne, Australia
Contact:
Status: Offline

Re: Who's using Arduino's

Post by Oz Flyer » 21 May 2020, 23:57

looking good.
One thing is so you can see them in the data monitor.
David
OZ Flyer
Near YMMB
40+ year of Flight Siming.
Sim: subLOGIC/Microsoft Flight Sim's/DTG FSX, Microsoft Flight, DTG Filght School/FSW/Train Sim/TSW, ETS2 & ATS.
Hardware: Logitech, Saitek, Arduino 2560's & Leo's, BBI-32, PAC LED.

lesoreilly
Captain
Posts: 221
Joined: 31 Jul 2015, 01:07
Status: Offline

Re: Who's using Arduino's

Post by lesoreilly » 28 May 2020, 18:18

I have not gotten around to my Uno TXPDR.....I need to do that. Just too busy with CoVid and work. I have not even flown the sim since early April :(

I have pretty much up to this point just used the Arduino for a GPS530....A Landing Gear Handle and some other switches...So those were all the Leonardo or the Pro Micro running in USB HID Mode....Which I like since I can then have them show up as "Buttons" and re-Program them in Spad like a Joystick....I guess I would be good if the Serial Interface could have "LEDs" or Buttons show up in a list for what they are to do...

Post Reply