Still working on the backlog of tickets. Please bear with me. If you have a licence-ticket that needs urgent attention update it to push it up.

Can't test when made a change

Discussion about Problems.
Forum rules
If you have technical Problem, please open a ticket:

Do NOT hijack other people threads, until you have exactly the same problem!
Post Reply
Posts: 1
Joined: 07 Jan 2020, 05:24
Status: Offline

Can't test when made a change

Post by tammi87 » 07 Jan 2020, 05:34

Hi Team,

I kinda new to this SPAD.NEXT but really love it. I have figure out the software for the most part and was able to create basic profiles for the MFP. Problem is that them i made a change to a knob or buttons I can't test it like most YT videos. When i make a change and try to spin the nob it won't do anything or show anything on the SPAD.NEXT. When i press the TEST button my MFP goes nuts, it goes over all the numbers on the screen like in matrix.
Any ideas??


User avatar
Site Admin
Posts: 5013
Joined: 10 Mar 2015, 21:52
Location: Munich, Germany
Status: Offline

Re: Can't test when made a change

Post by c0nnex » 09 Jan 2020, 13:31

If you change knob or button the changes will be active immediately after pressing ok. If they do not work as intended the programming is wrong ;)

Posts: 116
Joined: 10 Mar 2015, 22:00
Location: Christchurch, NZ
Status: Offline

Re: Can't test when made a change

Post by Hazza » 09 Jan 2020, 20:47

As the Boss said it will be your programming. It can be very frustrating but once you get it right it is the best feeling! What specifically are you trying to program? If it is "default " type aircraft (i.e. those that use default FSX/P3D key mappings) there are plenty of online Snippets and the ones by Connex will work. If it is a complex aircraft (PMDG, FSLabs, CaptainSim, TFDi, MilViz, A2A, etc) then there have been a number of Online Profiles (of varying quality!) posted by other users.

If you need assistance just post back and I will help as far as I can




Post Reply