FIP Flickering with XPlane

Discussions about new feature ideas.
To request a new feature please open a ticket
Post Reply
Captain Allan
Passenger
Posts: 3
Joined: 01 Oct 2019, 08:06
Status: Offline

FIP Flickering with XPlane

Post by Captain Allan » 09 Oct 2019, 00:16

Trying to get FIPs to work with XPlane but the FIP continually try's to go to burnout mode and flick from the gauge to the splash screen ?

User avatar
thedazman
Betatester
Posts: 1669
Joined: 28 Mar 2015, 10:47
Location: United Kingdom
Contact:
Status: Offline

Re: FIP Flickering with XPlane

Post by thedazman » 09 Oct 2019, 21:27

SPAD splash screens or manufactures splash screens ?

If Manufacturers then that's because you are running the original software drivers and SPAD at the same time. Basically overloading it with two inputs.

there's are plenty of posts on this forum about disabling the original drivers

but basically uninstall the original software and make sure directoutput service is disabled

Daz
"theDAZman" aka "theGFXguy"
Image
http://www.fipgauges.com

Post Reply