FIP Flickering with XPlane
-
Captain Allan
- Passenger
- Posts: 3
- Joined: 01 Oct 2019, 08:06
- Status: Offline
FIP Flickering with XPlane
Trying to get FIPs to work with XPlane but the FIP continually try's to go to burnout mode and flick from the gauge to the splash screen ?
-
thedazman
- Betatester
- Posts: 1669
- Joined: 28 Mar 2015, 10:47
- Location: United Kingdom
- Contact:
- Status: Offline
Re: FIP Flickering with XPlane
SPAD splash screens or manufactures splash screens ?
If Manufacturers then that's because you are running the original software drivers and SPAD at the same time. Basically overloading it with two inputs.
there's are plenty of posts on this forum about disabling the original drivers
but basically uninstall the original software and make sure directoutput service is disabled
Daz
If Manufacturers then that's because you are running the original software drivers and SPAD at the same time. Basically overloading it with two inputs.
there's are plenty of posts on this forum about disabling the original drivers
but basically uninstall the original software and make sure directoutput service is disabled
Daz
