Probably this is not going to work and I have to replace my Potmeter axis by a rotary encoder. But I thought lets give it a try...
Rotorbrake codes for ECP upper display dimming are 77025 to increase and 77024 to decrease
Is there a clever way to use a potmeter axis to control this VC dimming switch?
I remember using FSUIPC, I could use a TQ axis to set flaps using rotorbrake codes by assigning ranges up and down to the TQ axis.
Thanks for any feedback
Current SPAD.neXt Release: 0.9.12.123
This forum has closed. Please join our Discord Community.
SPAD.neXt online services are no longer available for SPAD.neXt Versions < 0.9.11.5
FSLabs 320 VC dimming knob using rotorbrake codes
FSLabs 320 VC dimming knob using rotorbrake codes
Saitek HW: ProFlight Yoke (upgraded with springs and a LeoBodnar JC), 2 TQs, 2 RPs, MP, SP
Other HW: MFG rudderpedals, Logitech Extreme 3D Joystick, DIY A320 glareshield (WIP; 3 BBI32s and 2 PACLED64s)
Other HW: MFG rudderpedals, Logitech Extreme 3D Joystick, DIY A320 glareshield (WIP; 3 BBI32s and 2 PACLED64s)
- c0nnex
- Site Admin
- Posts: 5469
- Joined: 10 Mar 2015, 21:52
- Location: Munich, Germany
- Contact:
- Status: Offline
Re: FSLabs 320 VC dimming knob using rotorbrake codes
Should be possible using the Range-Custom Axis programming
Re: FSLabs 320 VC dimming knob using rotorbrake codes
I have tried but have not been very successful so far. I couldn't figure out how to assign different actions to the same range depending on wether the range was entered via an increase or a decrease. I will spend some more time on it soon.
Saitek HW: ProFlight Yoke (upgraded with springs and a LeoBodnar JC), 2 TQs, 2 RPs, MP, SP
Other HW: MFG rudderpedals, Logitech Extreme 3D Joystick, DIY A320 glareshield (WIP; 3 BBI32s and 2 PACLED64s)
Other HW: MFG rudderpedals, Logitech Extreme 3D Joystick, DIY A320 glareshield (WIP; 3 BBI32s and 2 PACLED64s)