VERY low level request.
I used to have the FIP do a slide-show of pictures, airplane, kids, etc. when the sim wasn't running.
It was a simple matter of dropping pictures into the right folder, resizing wasn't all that important. When the sim would start up, the normal Saitek gauges would run. This was done with the regular Saitek FIP driver.
I may not be doing it right, but I can't replicate that "feature" anymore.
Current SPAD.neXt Release: 0.9.12.123
This forum has closed. Please join our Discord Community.
SPAD.neXt online services are no longer available for SPAD.neXt Versions < 0.9.11.5
FIP picture display
- OldAirmail
- Donator
- Posts: 172
- Joined: 10 Mar 2015, 22:00
- Status: Offline
FIP picture display
1 Saitek Switch Panel, 1 Radio Panel, 1 Multi Panel, 1 BIP, 1 FIP,
1 Saitek Rudder Pedal, 1 Saitek Throttle, 1 Saitek TPM, 1 Desktop Aviator GPS, 1 CH Yoke
Registered
1 Saitek Rudder Pedal, 1 Saitek Throttle, 1 Saitek TPM, 1 Desktop Aviator GPS, 1 CH Yoke
Registered
- thedazman
- Betatester
- Posts: 1808
- Joined: 28 Mar 2015, 10:47
- Location: United Kingdom
- Contact:
- Status: Offline
Re: FIP picture display
It's easy, you just have to re-install the saitek driver which was good at turning a FIP into a picture frame, but not much else and give up flying lol
You could create your own picture frame gauge quite easily in SPAD.neXt
Actually I think SPAD.neXt allows you to replace the splash screens now, pretty sure I read that somewhere
Daz
You could create your own picture frame gauge quite easily in SPAD.neXt
Actually I think SPAD.neXt allows you to replace the splash screens now, pretty sure I read that somewhere
Daz
- c0nnex
- Site Admin
- Posts: 5469
- Joined: 10 Mar 2015, 21:52
- Location: Munich, Germany
- Contact:
- Status: Offline
Re: FIP picture display
Complete edition only feature. Already there ... http://www.spadnext.com/manual/fip/spashscreens.html