blinking patterns!!!
Posted: 26 Dec 2020, 19:26
I have just one Saitek BIP.
I was trying to configure my BIP to use it with a KingAir 350
Then I noticed that there are a lot of duplicated alerts, for left and right:
Left and right engine fire
Left and right Pitot heat
Left and right fuel qty
Left and right fuel press low
Left and right oil press low
Left and right a/c bus
Left and right Enviro fail
Left and right bleed air fail
Left and right DC gen
Left and right FW Va;ve
Left and right ignition
and much more!
So, I thought that, I could use a diferent blinking pattern for left and right
even more, could be more for planes with 3 and 4 engines.
That way, I would need just one tile to the same alert for all the engines!
So, one flash could be for left and two flashes could be for right (engines 1 and 2!) and so on.
Is it too hard to implement?
Thanks Connex, sorry about my poor english!
I was trying to configure my BIP to use it with a KingAir 350
Then I noticed that there are a lot of duplicated alerts, for left and right:
Left and right engine fire
Left and right Pitot heat
Left and right fuel qty
Left and right fuel press low
Left and right oil press low
Left and right a/c bus
Left and right Enviro fail
Left and right bleed air fail
Left and right DC gen
Left and right FW Va;ve
Left and right ignition
and much more!
So, I thought that, I could use a diferent blinking pattern for left and right
even more, could be more for planes with 3 and 4 engines.
That way, I would need just one tile to the same alert for all the engines!
So, one flash could be for left and two flashes could be for right (engines 1 and 2!) and so on.
Is it too hard to implement?
Thanks Connex, sorry about my poor english!