Page 1 of 1

FIP Flickering with XPlane

Posted: 09 Oct 2019, 00:16
by Captain Allan
Trying to get FIPs to work with XPlane but the FIP continually try's to go to burnout mode and flick from the gauge to the splash screen ?

Re: FIP Flickering with XPlane

Posted: 09 Oct 2019, 21:27
by thedazman
SPAD splash screens or manufactures splash screens ?

If Manufacturers then that's because you are running the original software drivers and SPAD at the same time. Basically overloading it with two inputs.

there's are plenty of posts on this forum about disabling the original drivers

but basically uninstall the original software and make sure directoutput service is disabled

Daz