SPAD.neXt

Hi, I am new to this forum and I have purchased license for this software. I have decided to register in this forum because I have a problem and I can't find the key. I need help. In the Saitek Multipanel, specifically in VS mode, I have configured on the display so that the values ​​of the plane's altimeter can be seen. However I try to create an event to adjust the altimeter with the saitek multipanel wheel with the value "sim / instruments / barometer_up" X-Plane Special Value: Begin Command and Parameter Value: 1 But when moving the wheel it moves quickly and returns another time to his position where he had it. Can somebody help me? Thanks

The Value "Begin Command" means that X-Plane shall begin with the command, and REPEAT it until you explicitly send the "End Command". If you want to change tick by tick use "Execute Command", this will tell X-Plane to do the event exactly one time.