SPAD.neXt

Hi,
I’m currently in my 14day-trail of spad.next and already having a problem in the installation wizard.
I have two Logitech/Saitek FIPs (next to my autopilot... but they work fine ) and want to connect them to X-Plane with spad.next. The problem is, that I can’t figure out how to build up the connection via SimConnect (I only remember that from the good old FSX times...)?!

Any advise or ideas beside the instructions in the manual so that I can get my FIPs running on X-Plane

Thanks in advance

Thank you very much for the support!
I already tried your suggestet solution before without result.

Anyway, I did it again and it worked (can't explain what I did different - but hey: IT WORKS!)
Then I had the problem that the devices turned black with an internal device error while flying. I assumed it was the problem with the Saitek DirectOutput and with all the solutions in this Community I could manage it to work as it should!

Again: Thank you for the support!