Page 1 of 1

Gear Activation / Engine Shutdown

Posted: 15 Feb 2020, 20:01
by Eagle Spirit
While in my Milviz Beaver, water takeoff. As I clear the water I activate gear control lever (Saitek) to raise, at that moment the engine cuts off. As a result, I need to execute a midair engine restart. I'll be checking my key bindings today. Anyone experiencing this issue or have any suggestions?

Regards, Eagle

Re: Gear Activation / Engine Shutdown

Posted: 18 Feb 2020, 17:33
by c0nnex
MOst likely SaiSimFLightX is interfering with SPAD.neXt. DIsable it.

Re: Gear Activation / Engine Shutdown

Posted: 25 Feb 2020, 21:26
by Eagle Spirit
TYVM, but where is that located.

Eagle

Re: Gear Activation / Engine Shutdown

Posted: 26 Feb 2020, 23:08
by Eagle Spirit
I have searched my system and the internet, to no avail. No helpful information regarding "SaiSimFLightx". Did not see any trace of Saitek on my system.

Eagle

Re: Gear Activation / Engine Shutdown

Posted: 27 Feb 2020, 10:35
by lesoreilly
check to make sure that it is not under logitech either.... It has been a long time for me since I had to look at this but pretty sure this is a "service" that is being referred to here.

Re: Gear Activation / Engine Shutdown

Posted: 29 Feb 2020, 09:49
by thedazman
Think it’s saiflightsimx.exe at least that’s what’s it used to be called. Check task manager if there then you have to remove the source.

Daz