Page 1 of 1

Can't test when made a change

Posted: 07 Jan 2020, 05:34
by tammi87
Hi Team,

I kinda new to this SPAD.NEXT but really love it. I have figure out the software for the most part and was able to create basic profiles for the MFP. Problem is that them i made a change to a knob or buttons I can't test it like most YT videos. When i make a change and try to spin the nob it won't do anything or show anything on the SPAD.NEXT. When i press the TEST button my MFP goes nuts, it goes over all the numbers on the screen like in matrix.
Any ideas??


Re: Can't test when made a change

Posted: 09 Jan 2020, 13:31
by c0nnex
If you change knob or button the changes will be active immediately after pressing ok. If they do not work as intended the programming is wrong ;)

Re: Can't test when made a change

Posted: 09 Jan 2020, 20:47
by Hazza
As the Boss said it will be your programming. It can be very frustrating but once you get it right it is the best feeling! What specifically are you trying to program? If it is "default " type aircraft (i.e. those that use default FSX/P3D key mappings) there are plenty of online Snippets and the ones by Connex will work. If it is a complex aircraft (PMDG, FSLabs, CaptainSim, TFDi, MilViz, A2A, etc) then there have been a number of Online Profiles (of varying quality!) posted by other users.

If you need assistance just post back and I will help as far as I can



Re: Can't test when made a change

Posted: 29 Jan 2020, 16:12
by tammi87
Thank you for an update. I was able to get that test portion to work. I have another small issue but will search here before i post it cause probably ran into the same thing.