SPAD.neXt

So I'm using Spad for the first time to run a Logitech Switch panel. I was really impressed so far with the software but ran into a snag. Spad wont output the axis of my X56 to a Vjoy device so I'm force to use Joystick Curves to do the job. Problem is that joystick curves takes priority of Vjoy and blocks Spad from sending any inputs at all. Is there some way to send my throttle axis to a vjoy axis so I can ditch JC?

That's currently not possible, but a good suggestion.
I'll add a "Passthrough"-AxisEvent to all Axis. (Should be available in Beta 0.9.7.3 or 0.9.7.4)

Awesome, for the short term I'm using a work around with the default logitech software, thanks for the quick reply.