SPAD.neXt

The reason I ask is my Saitek throttle quads haved worked with the simpla SPADNext Configure Left Lever window using the selection 'Throttle without Reverser'. Right now it works with the MSFS default A320 Neo and the B747. However, it no longer works with the FlyByWire A320. The Throttles are setup in SPADNext but no longer move in the FBW A30 cockpit?

I am not sure if this happed after the MSFS Update 6 or not? Also, not sure if this is related but the SPADNext bridge module... is that still in effect to place that in the community folder? Is there a new version with Update 6?

Any input would be appreciated.

Clutch

As I continue to research, maybe this has to do with LVARs? Again, maybe connected to the SPADnext bridge module? Looking around as to where I can download this? If I recall SPADnext sort of detected the need for this in the past but I am not seeing this now?

Just an update. I re-downloaded the SPADnext bridge module. It installed it into the community folder but still no response from the throttle levers in the A320 cockpit but thay are moving in the SPADnext animated simulated window. ???

I gave up using FBW as they change stuff too often and can’t keep up with them. It’s possible the aircraft changed its LVARS. Hope you get to the bottom of it you can test if other LVARS are outputting in the data monitor that should rule out it bing a bridge issue

ok i downloaded program to try but says activate rather than 14 days trial i run flight sim 2020 and want to run my mcppro not paying till i know it works