SPAD.neXt

I'm a few days into my 2 week trial and I've watched several of Les's videos and have successfully mapped a few functions on my Alpha Yoke however I cannot use the Event Monitor at all. I'm in the C172 cockpit and when I start the Event Monitor it begins an endless loop with Events: MSFS:RADIO_COMMNAV1_TEST_TOGGLE and MSFS:RADIO_COMMNAV2_TEST_TOGGLE

I can clear them by clicking on the Ignore Event button but then they won't show up when I actually do click on them in the cockpit. I guess the simple question is, why are these two functions in an endless loop?

Thanks for any feedback.

Ask the MSFS devs
SPAD just shows what MSSF sends to it

Ok, thanks. I figured this had to be happening to others and maybe there was a known solution.

Regards

Actually, I mistakenly wrote C172 above and this is actually happening in the C152. I just loaded into the C172 and don't have this looping problem.