Page 1 of 1
New to Spad
Posted: 04 Jul 2021, 20:29
by otrman
I have just joined looking for a solution to a problem I have. I am new to MSFS and using Honeycomb Alpha and Bravo as c controllers. I don't line using autopilot with the Bravo and have just installed a Saitek multichannel Which does not appear in my list of connected devices in the Options section of MSFS. I would like to use this in place of the Bravo.
Does SPAD provide a solution for me?
Thanks in advance,
Otrman
Re: New to Spad
Posted: 04 Jul 2021, 21:38
by Redscouse
Hi Otrman,
I don't have the bravo controller but I do use the Alpha Yoke. It works fantastic with Spad.Next.
Go to the main site using the 'Home' link above, download it and try it.
There is a time limited demo allowing you to try before you buy.
Hope that helps,
Pete.
Re: New to Spad
Posted: 05 Jul 2021, 16:37
by otrman
Hello Pete,
My Alpha is doing fine. The Bravo only works with MSFS and the AP works but I just don't like it. I also use XP-11 and could not get the Bravo AP working with XP-11 so I bought the Logi Flight Panel which is basically used for AP. Saitek acquired Logitech and the I can use AP with XP-11. If I am using MSFS I just turn off the Saitek.
I would like to use the Saitek autopilot with both XP-11 and MSFS and was hoping that SPAD might have a solution.
otrman
Re: New to Spad
Posted: 05 Jul 2021, 17:25
by Redscouse
Hi Otrman,
If I understood your last post correctly, you have to turn off the multi panel device when using MSFS?
You don't need to do that.
If you have the Saitek/Logitec drivers installed, they remain in control over the devices rather than Spad.Next.
These drivers need to be uninstalled for Spad.Next to control the device.
I have the Switch panel, Multipanel, 2x radio panels. from Saitek/Logitec and they all play nice with Spad.Next after removing the native drivers.
If I misunderstood your post, then forget everything I've written above.
Pete.