Page 1 of 1

Saitek Multi Panel Knob Problem

Posted: 07 Sep 2016, 08:17
by baranismen
Hey everyone. I'd like to ask something. I've recently installed and started using SPAD.neXt for my Multi Panel. Works OK, but the knob increases and decreases the values way too fast even in "1" Value setting. When i use the older Spad 0.5, it works flawless, but as it lacks the functionalities of neXt, i dont want to use it. Only if i can solve this "hasty" knob issue, i'll be most grateful :)

Any ideas ?

Re: Saitek Multi Panel Knob Problem

Posted: 07 Sep 2016, 19:25
by c0nnex
Which knob ? Which Values? Which Profile? Which aircraft?

Re: Saitek Multi Panel Knob Problem

Posted: 07 Sep 2016, 20:00
by baranismen
Rotary knob, the one that we change the values like altitude, ias, heading vs. In default profile i suppose, it's free version right now, so i dont think i have a choice to select any other profiles than the Default FSX one.

Tried with both default and add-on planes, all same. Rotary knob changes the values way too fast, i have to be veeery precise and slow to get 1 decimal changes.

Re: Saitek Multi Panel Knob Problem

Posted: 07 Sep 2016, 22:29
by c0nnex
Sounds like another software is interfering with the panel communication and sending updates as well.

make sure no other software does anything with the panel.
If SPAD.neXt is NOT running and you turn the knob NOTHING must happen.

Re: Saitek Multi Panel Knob Problem

Posted: 09 Sep 2016, 21:30
by baranismen
I can assure you that nothing else but SPAD.neXt is working while it's active :(

Re: Saitek Multi Panel Knob Problem

Posted: 09 Sep 2016, 23:19
by c0nnex
Hmm cannot reproduce this with the "default - FSUIPC Base" profile.
Can you please send a logfile to support@fsgs.com ( log is in %APPDATA%\SPAD:neXt\logs )