I have a multi panel and a switch tech panel. I just got the A10 Hotas and its programming software. I see I can program the Hotas with Sapdnext as well.
Should I use Spadnext for the hotas buttons, or the Hotas software?
Mark
Current SPAD.neXt Release: 0.9.12.123
This forum has closed. Please join our Discord Community.
SPAD.neXt online services are no longer available for SPAD.neXt Versions < 0.9.11.5
A10 hotas
-
- Captain
- Posts: 272
- Joined: 31 Jul 2015, 01:07
- Status: Offline
Re: A10 hotas
I would use Spad.Next.....Why would you give up the ability to have one software to configure everything for every aircraft??....
-
- Passenger
- Posts: 2
- Joined: 30 Jan 2020, 15:05
- Status: Offline
Re: A10 hotas
Thanks for the input. I’m thinking I’m seeing some of the buttons on the Hotas already set. I’ll need to figure out how to turn off some of the settings so I can use them in Spadnext.
-
- Captain
- Posts: 272
- Joined: 31 Jul 2015, 01:07
- Status: Offline
Re: A10 hotas
I would uninstall any software form the vendor -- ie I do that will all of my saitek / logitech products. Then you have to go into P3D or FSX an remove all of the buttons and axis they assign. every time you add a new controller this can pop up on you...it is a pain.