Brand New Radio Panel Stops Responding

[fabristunt]

Hi there,
today I got my new radio panel and I am facing an issue.
I configured it do what I want and it works... for a few minutes. THen it kinda stops responding. I cannot read the position of the COM1, 2 Nav 1,2 ADF XPDR selectors. Their position does not update in spad.Next, but the displays revet to COM1 and COM2. In this situations the displays still read correctly the info from the sim, but I can't do anyyhing with them.

I am running P3D v4.5, with the A2A C182. My spad version is 0.9.6.54.


When this happens, the rest of my saitek stuff still works correctly. I have a Switch Panel, Yoke, Rudder pedals, two Throttle Quadrants (one plugged into the Yoke).
The switch panel, the rudder pedals, the USB throttle quadrant and the radio panel are plugged into a USB Hub (5V/2.5A), while the yoke goes into a USB port on the Case.

Did I receive a faulty unit or is there something I can try before asking for a substitute?

Regards,
Fabrizio

[c0nnex]

You have an USB Powermanagement issue. That's the reason why ignoring the warning when SPAD.neXt starts is not a good idea.
Disable USb Powermanagemnt for the radio panel in windows device settings.