I have previously posted a couple of questions and luckily by fiddling, managed to find a solution or work around.
This is what I have done so far to use a switch G7 in the TPM to actuate the A2A C172 Annunciator panel from DIM to BRT, but only if the Battery is ON
My setting below:
- TPM G7: Switch UP (Conditional) > Set ANNUNCIATORPANELTESTSWITCH (LVAR) to 1
The condition (Simconnect): ELECTRICAL MASTER BATTERY equals ON
- TPM G7: Switch DOWN > Set ANNUNCIATORPANELTESTSWITCH (LVAR) to 0
My solution so far was to assign T5 from the Pro Quadrant as the "temporary switch" to TST. It works, but not quite as I would like... Yes, I know...I should get a life! I did, I retired and now I spend ridiculous time messing around Flight Simulation - so, back to the crunch.
- Quadrant T5: Button pressed > Set ANNUNCIATORPANELTESTSWITCH (LVAR) to 2
Button Mode: "Repeat: triggered every 25ms until released"
And it works great! BUT, me again, there is a better choice for the Button Mode, "Short: Triggered shortly and release within 500ms" which doesn't work at all. I would like to short press the button T5 once and get the same result as above.
Is there anyone with a suggestion that does not require more than a few clicks in SpadneXt? Thank you for reading.
?