Ok next hurdle i have come across is the AP Mode. I have tried all of the A2A listed LVARs for AP MODE but i am not able to change the APO Mode through ST - HD- TRK at all. I have been trying to set this up with the Multipanel HDG button.
Is this possible?
A2A AP LVARs listed are
(L:ApMaster,bool) - master switch
(L:ApModeYokeSwitch,bool) - mode button (yoke). Cycle modes by setting it to 1 and back to 0
(L:ApAltSwitch,bool) - alt. hold button (yoke). Trigger alt hold by setting it to 1 and back to 0
(L:ApDisconnectSwitch,bool) - dsiconnect button (yoke). Set it to 1 and back to 0.
(L:ApModePushSwitch,bool) - mode knob (bazel). Cycle modes by setting it to 1 and back to 0
(L:ApTurnKnob,percent) - turn knob (bazel). Range -50 - 50.
Current SPAD.neXt Release: 0.9.12.123
This forum has closed. Please join our Discord Community.
SPAD.neXt online services are no longer available for SPAD.neXt Versions < 0.9.11.5
A2A Comanche AP Mode
Re: A2A Comanche AP Mode
Hi Ulrich,
Hopefully you may be able to offer some advice on this. I have a push button in the A2A Comanche which sets the autopilot heading/tracking mode and another which sets the Alt Hold function. I have identified the LVAR in the sim and got them sort of working but the issue is that the clickspot in the sim is a momentary button where when you press it, it will go in and then pop out. In doing so it will toggle the bit/even from 0 to 1 when pushed and then from 1 to 0 when released. Once it has been pushed and released (ie toggled 0-1-0) it will activate the function.
What is the best way to replicate this in Spad? I have tried just pressing the addisned button twice and that works but i would like to get it to work with one press.
Would it work to assign two commands to the button push the first to togglebit 0 to 1 and then the second to toggle bit 1 to 0?
Hopefully you may be able to offer some advice on this. I have a push button in the A2A Comanche which sets the autopilot heading/tracking mode and another which sets the Alt Hold function. I have identified the LVAR in the sim and got them sort of working but the issue is that the clickspot in the sim is a momentary button where when you press it, it will go in and then pop out. In doing so it will toggle the bit/even from 0 to 1 when pushed and then from 1 to 0 when released. Once it has been pushed and released (ie toggled 0-1-0) it will activate the function.
What is the best way to replicate this in Spad? I have tried just pressing the addisned button twice and that works but i would like to get it to work with one press.
Would it work to assign two commands to the button push the first to togglebit 0 to 1 and then the second to toggle bit 1 to 0?
- c0nnex
- Site Admin
- Posts: 5469
- Joined: 10 Mar 2015, 21:52
- Location: Munich, Germany
- Contact:
- Status: Offline
Re: A2A Comanche AP Mode
Just add 3 actiones to the press event:
- Change Data Value of the LVAR to 1
- Delay Next Action 500ms
- Change Data Value of the LVAR to 0
- Change Data Value of the LVAR to 1
- Delay Next Action 500ms
- Change Data Value of the LVAR to 0
Re: A2A Comanche AP Mode
Cheers, will give that a try