Current SPAD.neXt Release: 0.9.11.5

This forum has been set to readonly. Helping/Q&A etc is done exclusivly on Discord.

SPAD.neXt online services are no longer available for SPAD.neXt Versions < 0.9.11.5
The .Net-Framework used by SPAD.neXt has a faulty configuration (long known by MS, but refused to be fixed) which prevents those older versions to connect to the services now, because old TLS-Protocol has been disabled by Microsoft in latest Windows updates.
If you have trouble updating to latest version because your Windows updated already, you can download the latest installer here and install it over your existing installation.

MSFS2020 - Asobo Kingair 350 - Engine Condition Control

Locked
Raldan
Passenger
Posts: 1
Joined: 21 Oct 2021, 04:09
Status: Offline

MSFS2020 - Asobo Kingair 350 - Engine Condition Control

Post by Raldan » 21 Oct 2021, 04:30

Hello everyone,

I'm using SPAD.next to communicate between the CH Products Throttle Quadrant and the Asobo Kingair 350i.

Specifically, before Sim Update 6, I'd use the "Mixture" levers to control the Engine Condition levers.
From what I understand, there are three states these levers can be in, High Idle, Low Idle, and Cutoff.
(I'm not a pilot and have never been in a KingAir, so forgive my ignorance)
Before the update, the levers could be adjusted using an Axis which is what the levers on the TQ supply.

After the update, Asobo has changed the levers to a three-state switch that does not respond to an axis control.
Watching the Event monitors shows nothing when I adjust the levers with the mouse. Maybe a new parameter?

Has anyone found any data or events that we could exploit here?

Thanks for your help!

Locked