Saitek FIP Do not start
Posted: 08 Jun 2021, 01:54
Hello, I have a problem with a FIP module, I restart it by unplugging it then plugging it back in, but each time I only have the top red arrow that lights up, unlike the other FIPs that I have arrows do not blink.
as if it was bugged, as if the startup phase does not end.
do you have any idea how i could retrieve this module? or is it good to go in the trash?
it's probably a hardware problem, nothing to do with the drivers, SpadNext or the usb ports, I have 8 others that work perfectly.
I can not find how to do a hard reset, or the firmware to reprogram it.
thanks in advance
as if it was bugged, as if the startup phase does not end.
do you have any idea how i could retrieve this module? or is it good to go in the trash?
it's probably a hardware problem, nothing to do with the drivers, SpadNext or the usb ports, I have 8 others that work perfectly.
I can not find how to do a hard reset, or the firmware to reprogram it.
thanks in advance