Page 1 of 1

propwashsim.com

Posted: 08 Feb 2018, 04:55
by Oz Flyer
Dose any one know if propwashsim.com is still trading I posted a comment on one of there parts and sent an email over a week ago and have had no reply.

Re: propwashsim.com

Posted: 09 Feb 2018, 01:14
by lesoreilly
I see their dual encoders on eBay all the time. I bought some not too too long ago. They work great. I would call them Half Steps. So 2 steps per click. They work well with the Joystick Sketch that was linked in the Arduino thread.

Also the newer knobs are metal and have set screws so they are firmly attached and have a great feel to them.

Re: propwashsim.com

Posted: 11 Feb 2018, 08:20
by Oz Flyer
lesoreilly wrote:I see their dual encoders on eBay all the time. I bought some not too too long ago.
Thanks all sorted they got back to me after sending another email.
Have ordered and they are on the way.

Do not need knobs, Going to 3D print ones that look like the ones on the GPS 500.