propwashsim.com

Discussion about special hardware
Post Reply
User avatar
Oz Flyer
Betatester
Posts: 673
Joined: 23 Sep 2015, 10:10
Location: YMMB, Melbourne, Australia
Contact:
Status: Offline

propwashsim.com

Post by Oz Flyer » 08 Feb 2018, 04:55

Dose any one know if propwashsim.com is still trading I posted a comment on one of there parts and sent an email over a week ago and have had no reply.
David
OZ Flyer
Near YMMB
40+ year of Flight Siming.
subLOGIC/Microsoft Flight Sim/DTG, Microsoft Flight, DTG FSW.

lesoreilly
Captain
Posts: 188
Joined: 31 Jul 2015, 01:07
Status: Offline

Re: propwashsim.com

Post by lesoreilly » 09 Feb 2018, 01:14

I see their dual encoders on eBay all the time. I bought some not too too long ago. They work great. I would call them Half Steps. So 2 steps per click. They work well with the Joystick Sketch that was linked in the Arduino thread.

Also the newer knobs are metal and have set screws so they are firmly attached and have a great feel to them.

User avatar
Oz Flyer
Betatester
Posts: 673
Joined: 23 Sep 2015, 10:10
Location: YMMB, Melbourne, Australia
Contact:
Status: Offline

Re: propwashsim.com

Post by Oz Flyer » 11 Feb 2018, 08:20

lesoreilly wrote:I see their dual encoders on eBay all the time. I bought some not too too long ago.
Thanks all sorted they got back to me after sending another email.
Have ordered and they are on the way.

Do not need knobs, Going to 3D print ones that look like the ones on the GPS 500.
David
OZ Flyer
Near YMMB
40+ year of Flight Siming.
subLOGIC/Microsoft Flight Sim/DTG, Microsoft Flight, DTG FSW.

Post Reply