I have the Complete Edition but still need to update my subscription soon.

Has anyone done this yet?

Does anyone know how to do this?

There has to be many other people in the same situation as this new system started in November 2016.

Can someone please help?
Thanks

I see from the settings page of Spad Next that my subscription runs out on the 29 Nov 2017.

There is a line on the settings page that says Update Subscription, but when I high light it nothing happens.

How do I Update my Subscription before it runs out?



Thanks
Roger

I control all axes and buttons in FSX and P3D with FSUIPC I do have the full version of Spad Next. Fuspic does not work very well with A2A Aircraft as I found out,because of the L:vars I guess? What are other people using to control Axes and buttons on A2A aircraft. Is there a way to do it using Fus...

Ok so I tested to port where the yoke is normally plugged . I plugged a usb thumb drive in the spot that has been used for the yoke and it works fine therefore there is nothing wrong with that port on the hub. I tried the thumbnail drive in each of the built in ports on the yoke itself and they do n...

Thank you very much For helping.

Will try what you suggest and keep digging!

But I think it looks very much like it's toasted!

Don't know what to do for a yoke I am afraid to try another Saitek.

Ok thanks will try what you said above.

No Ding Dong when I connect Yoke to either computer.

And Yes the green LED acts the same on both computers.
When USB for yoke is turned on all that happens is the Led on throttles lights up then goes out when yoke is turned off.

Thanks for the reply There is nothing with an exclamation mark in Device Manager. I turn the power off for all my devices ( the on/off switch on hub) when I finish using the sim,but the powered hub itself stays on as long as the computer is on. Can the yoke usb chip still get roasted (when the port ...

I also found my Saitek Pro Flight yoke toasted yesterday. Don't think it had anything to do with that Insider Preview as I did not install that as far as I Know? Last Windows update was on 3/16/2017. I run Windows 10. I have all my devices plugged into powered hubs (USB 2.0 for Saitek) all hubs have...

I would like to see X Plane as supported by simconnect as possible cause at the moment there is not much available for online snippets that can be used with X Plane only thing at the moment as far as I can see is the X Plane profile. As far as I can see It would make using Spad with X Plane much eas...

I see quite a few online snippets that are calling for both fusplc and simconnect and would like to do the same thing.

What are the drawbacks to doing this?
Does it slow down your computer if it's not powerful enough?