Current SPAD.neXt Release: 0.9.10.0
Search found 5 matches
Search found 5 matches • Page 1 of 1
Well, this turned out to be very simple to solve -- I hadn't seen that the 'Change Data Value' action had 'increment' and 'decrement' operations until just a few minutes ago. Once I found that, it was easy to add flap 'steps'.
I've recently added the Aerobask Lancair Legacy to my X-Plane 11 hangar and have run into a new and interesting issue with the Saitek Multipanel and SPAD.neXt. The flaps on the Legacy don't have fixed positions. The flap switch in the cockpit is really just an electrical switch - it drives the flaps...
- 29 Nov 2019, 05:52
- Forum: Feature Ideas / Discussions
- Topic: An alternative Flight Instrument Panel?
- Replies: 30
- Views: 11209
A higher-resolution display is essential, as is the need to be able to create just about any instrument for each FIP.
I posted this same question to the 'Registered' forums in the 'Support' topic but then realized I might get a faster response here. Here's my question: I recently added a three-position landing gear lever to my sim and have run into a puzzling issue with getting the correct DOWN/UP/OFF states to wor...
PMDG aircraft have a large number of custom controls defined in their SDK folder. In particular, I'm interested in the idle/cutoff switches for engine 1 and 2 (for the 737NGX). The actual values needed are 70320 + a parameter (0 for idle / 1 for cutoff) and 70321 (for engine 2, same parameters). In ...