You're right!

Not .78 has been shown but IAS 780. The .78 are shown on the MCP - my fault

Aircraft: PMDG 737NGX Simulation: FSX Snippet: Display Value Display IASMach clockwise turn ... counterclockwise turn... You can change the value if it is <10 (i.e. 0.67) and change the parameter to multiply it with 100 but then the display shows 67 without a leading decimal point. Uli, I found this...

Hi all, I use a Saitek Multi Panel and use an snipped to show the Mach speed but it doesn't work. The device only shows a 1. With the original Saitek driver the correct Mach speed is shown. I took an online snippet that uses the PMDG-settings from IASMach. But when reaching the Mach area or when I m...

C0nnex is right. All Bodnar boards have the same ID. So you should change the firmware on the card to make it unique.
Look into the Download area for your card and you will be able to solve your problem

Take a look on Leos Site: http://www.leobodnar.com/shop/ and got to the USB boards.

Every board has a download section. There you can download special firmware which make you able to use up to 10 cards with different IDs. If you need more, you should contact him.