The feature to switch panels according to a condition is great.
But, would it be possible to have multiple conditions?
Example: To switch Radio and multi panels on, battery volt must be more than 0V and battery switch on and avionic.
Thanks
Orangina
Current SPAD.neXt Release: 0.9.12.123
This forum has closed. Please join our Discord Community.
SPAD.neXt online services are no longer available for SPAD.neXt Versions < 0.9.11.5
Panel on/off conditions
- c0nnex
- Site Admin
- Posts: 5469
- Joined: 10 Mar 2015, 21:52
- Location: Munich, Germany
- Contact:
- Status: Offline
Re: Panel on/off conditions
Right now you can add more than one condition already (use the "+" next to any of the conditions), however the evaluation is "OR".
Since this is needed for the BIP as well, I'm working on a concept already to allow selection if the binding shall be AND or OR .
Since this is needed for the BIP as well, I'm working on a concept already to allow selection if the binding shall be AND or OR .
- OldAirmail
- Donator
- Posts: 172
- Joined: 10 Mar 2015, 22:00
- Status: Offline
Re: Panel on/off conditions
AND / OR would be incredible!
Good luck, and thank you.
Good luck, and thank you.
1 Saitek Switch Panel, 1 Radio Panel, 1 Multi Panel, 1 BIP, 1 FIP,
1 Saitek Rudder Pedal, 1 Saitek Throttle, 1 Saitek TPM, 1 Desktop Aviator GPS, 1 CH Yoke
Registered
1 Saitek Rudder Pedal, 1 Saitek Throttle, 1 Saitek TPM, 1 Desktop Aviator GPS, 1 CH Yoke
Registered
- thedazman
- Betatester
- Posts: 1808
- Joined: 28 Mar 2015, 10:47
- Location: United Kingdom
- Contact:
- Status: Offline
Re: Panel on/off conditions
agree, would be very useful
Daz
Daz
- c0nnex
- Site Admin
- Posts: 5469
- Joined: 10 Mar 2015, 21:52
- Location: Munich, Germany
- Contact:
- Status: Offline
Re: Panel on/off conditions
Confirmed for 0.8