Page 1 of 1

Event Monitor & SimConect

Posted: 01 Mar 2016, 09:58
by Oz Flyer
Hi Ulrich,
Could you please look at adding a button to load "All SimConect" the same as LVAR's and Local's in to the monitor.

If you "do not" know what a 3rd party aircraft remaps something too it is easy to add all and delete the values that are changing all the time until you have none reporting.

Then move the control and see what reports.

This is how I have found many LVAR's.

Re: Event Monitor & SimConect

Posted: 01 Mar 2016, 10:57
by thedazman
You might Melt SPAD.neXt or your PC There a lot :-)

I'm on the same thought pattern, but I would like to sellect multiple definitions and add them at the same time so you don't have to add Event monitor event one at a time. Personally I wouldn't want to add a thousand definitions and remove them one at a time ;-)

Daz

Re: Event Monitor & SimConect

Posted: 01 Mar 2016, 12:37
by Oz Flyer
May by groupings as in the left panel of Add Data then you could load them in one group at a time until you got to many to work with.

Re: Event Monitor & SimConect

Posted: 02 Mar 2016, 00:35
by c0nnex
Adding all simconnect is no option, as it will make SPAD.neXt incredibly slow. I'll see if I can think of something nifty.

Re: Event Monitor & SimConect

Posted: 02 Mar 2016, 07:12
by Oz Flyer
Hi Ulrich,
What about by groups, Under "Add Data" / "SimConnect" you have them grouped.
Aircraft/Autopilot Data
/Avionics Data
Etc.
Then it would be up to the user as to how many groups they added at one time.