Hi,
Trying to make a setup for PMDG737, I find a request feature. To have a repeat option for an action.
Example for PMDG, you have to click twice the left button on the landing gear button to lower the gear.
So if I put for the "gear down" action, "simulation control" PMDG737 "Gear lever" single click left mouse button, it's only unlock the gear not down, it have to be done twice.
If there was the repeat option (with a timer), I think we could use it to repeat the action twice with half a second between the two action.
Orangina
Current SPAD.neXt Release: 0.9.12.123
This forum has closed. Please join our Discord Community.
SPAD.neXt online services are no longer available for SPAD.neXt Versions < 0.9.11.5
Repeat event
- c0nnex
- Site Admin
- Posts: 5469
- Joined: 10 Mar 2015, 21:52
- Location: Munich, Germany
- Contact:
- Status: Offline
Re: Repeat event
I'll look into that. You can achieve that right now, but adding a second action to the gear down event. But I don't know if the PMDG will handle it correctly if two Lever-Commands coming in short sequence.
Re: Repeat event
Already try, it doesn't work.
- c0nnex
- Site Admin
- Posts: 5469
- Joined: 10 Mar 2015, 21:52
- Location: Munich, Germany
- Contact:
- Status: Offline
Re: Repeat event
OK then I'll look into control-macros
- c0nnex
- Site Admin
- Posts: 5469
- Joined: 10 Mar 2015, 21:52
- Location: Munich, Germany
- Contact:
- Status: Offline
Re: Repeat event
Will be implemented in 0.9