SPAD.neXt

Following Problems are already known and being worked on:

* FIP: Gauge-Label editor not working (Not reproducible)
* FIP: Brightness not adjustable via Variable-Change (Fixed in 0.9.6.4)
* FIP: Gauges do not move when switching profiles (Fixed in 0.9.6.4)
* FIP: Gauges with Profile-Variables do not update when switching Profiles (Fixed in 0.9.6.4)
* vFIP: Client only loads first gauge / stops updating (FIxed in Beta 0.9.6.7)
* Multipanel Knob: Acceleration not working

FSW/P3dv4:

FSW:
Connection supported.
LVAR Bridge will be released asap.
Aircraft Indexing: supported (Beta 0.9.6.8)

P3D v4:
Connection supported.
LVAR Bridge: supported (Beta 0.9.6.13)
Aircraft Indexing: supported (Beta 0.9.6.8)

FSUIPC5: Fully supported.

Neither FSW nor P3dv4 or FSUIPC5 will be recognized by the Configuration WIzard pre Beta 0.9.6.8! Just enable SimConnect/FSUIPC in Settings->Application->Simulations


Current Public Release: 0.9.6.4
Current Beta: 0.9.6.13

Updated known issues

Update

Update

Updated first post

c0nnex


Just a clarification?

vFIP: Client only loads first gauge (FIxed in Beta 0.9.6.5)

( on remote client )It loads more gauges but still does not operate. all gauges come to stop after seconds or minutes.

It is still considered not fixed as far as you are conserned is this correct. and it will have to be worked on more some time in the future.
Thankyou for your great work.

Just clarifying the status of vFip client not operational.

bsmart wrote:
( on remote client )It loads more gauges but still does not operate. all gauges come to stop after seconds or minutes.

It is still considered not fixed as far as you are conserned is this correct. and it will have to be worked on more some time in the future.

Problem is known and will be adressed bei tonight´s beta update.

Just wanted to let you know that vfip client is working amazingly well with lastes ver 0.9.6.8. I just had prepar3d V4 working with 63 gauges spread across 3 client computers. I would never run this many in a cockpit build but i just tried to load it up how much the delay was. in my opinion it was still very workable. Amazing

Connex Rocks!

This is what will make cockpit builders gauge displays a lot easier to implement. Thank you so much for your great program with Spad. next and the vfip client.

According to an anonymous source P3D scheduled an update for next week. So let's wait and see.

The fix is published:
http://www.prepar3d.com/news/2017/06/114375/