I'm a few days into my 2 week trial and I've watched several of Les's videos and have successfully mapped a few functions on my Alpha Yoke however I cannot use the Event Monitor at all. I'm in the C172 cockpit and when I start the Event Monitor it begins an endless loop with Events: MSFS:RADIO_COMMNAV1_TEST_TOGGLE and MSFS:RADIO_COMMNAV2_TEST_TOGGLE
I can clear them by clicking on the Ignore Event button but then they won't show up when I actually do click on them in the cockpit. I guess the simple question is, why are these two functions in an endless loop?
Thanks for any feedback.
Current SPAD.neXt Release: 0.9.12.123
This forum has closed. Please join our Discord Community.
SPAD.neXt online services are no longer available for SPAD.neXt Versions < 0.9.11.5
New to Spad with question on event monitor
- c0nnex
- Site Admin
- Posts: 5469
- Joined: 10 Mar 2015, 21:52
- Location: Munich, Germany
- Contact:
- Status: Offline
Re: New to Spad with question on event monitor
Ask the MSFS devs
SPAD just shows what MSSF sends to it
SPAD just shows what MSSF sends to it
Re: New to Spad with question on event monitor
Ok, thanks. I figured this had to be happening to others and maybe there was a known solution.
Regards
Regards
Re: New to Spad with question on event monitor
Actually, I mistakenly wrote C172 above and this is actually happening in the C152. I just loaded into the C172 and don't have this looping problem.